AE3S-DS30P1 Diffuse Photoelectric Sensor,
| Type and Specification | |||
|---|---|---|---|
| Type | Square type | ||
| Dimension | 20*20*64mm | ||
| DC type | NPN | NO | AE3S-DS30N1 |
| NC | AE3S-DS30N2 | ||
| NO+NC | AE3S-DS30N3 | ||
| PNP | NO | AE3S-DS30P1 | |
| NC | AE3S-DS30P2 | ||
| NO+NC | AE3S-DS30P3 | ||
| AC type | Two-wire | NO | AE3S-DS30A1 |
| NC | AE3S-DS30A2 | ||
| Detection range | 10-30cm±10% | ||
| Detection target | Transparent/opaque object | ||
| Detection range regulation | Sensitivity controller | ||
| Response time | 30ms | ||
| Response frequency | DC: 0.5kHz, AC: 25kHz | ||
| Delay distance | ≤10% detection distance | ||
| Connection delay | 1.5ms | ||
| Light source | Infrared light 660nm | ||
| Supply voltage | DC type: DC 12-24V (6-36V), Impulse (p-p) 10% below; AC type: AC 110-220V (90-250V) 50/60Hz |
||
| Withstand voltage | AC1000V 50/60Hz 1min, between charging part and housing |
||
| Voltage influence | Inside ±15% rated supply voltage range, at rated supply voltage value, inside ±10% detection distance |
||
| Power current | ≤3VA | ||
| Control output | ≤2A (contact service life: 0.1 million times) | ||
| Allowed impulsion and vibration | B≤30g, T≤11ms, f≤55Hz, a≤1mm | ||
| Ambient temperature & humidity | Operation temperature/storage temperature: -30~65℃ (no freeze, no drew); Operation humidity/storage humidity: 35~95%RH |
||
| Temperature influence | Temperature range -30~65℃, at +23℃, ±15% detection distance; Temperature range -25~60℃, at +23℃, ±10% detection distance |
||
| Insulation impedance | ≥50MΩ (DC500 megameter), between charging part and housing |
||
| Material | Housing: Aluminum die casting (ABS), Detection surface (lens): PMMA |
||
| Protection class | IP65 | ||
| Cable length | 2m | ||
